CNCelite 8058 / 8060 / 8065 / 8070

Error 3088 · CNCelite 8058 / 8060 / 8065 / 8070

Message: Error when programming the laser mask

Detection

During laser cutting (synchronized switching).

Cause

The necessary hardware and parameter setting conditions to use the laser cutting feature are not met.

Solution

Check the following conditions:

  • There must be a Sercos type expansion board, with software ID equal to or higher than 1.2.
  • The value of parameter NLOCOUT must be 8.
  • The value of parameter PWMOUTPUT must not be higher than 2 (0, 1, 2).

8058 80608065 8070 ꞏ152ꞏ

The same code on other products

·