CNCelite 8058 / 8060 / 8065 / 8070

Error 2534 · CNCelite 8058 / 8060 / 8065 / 8070

Message: #ORBIT: the slot width and the feedrate must be greater than zero.

Detection

During editing and execution.

Cause

The parameter W (slot width) or B (pitch) is negative or zero.

Solution

Both values must be positive. The parameter W must be greater than the tool diameter, and less than or equal to twice the diameter of the active tool. Parameter B must be less than or equal to the diameter of the active tool.

·