CNC 8058 / 8060 / 8065 CNC 8070 CNCelite 8058 / 8060 / 8065 / 8070

Error 2438 · CNC 8058 / 8060 / 8065 · CNC 8070 · CNCelite 8058 / 8060 / 8065 / 8070

Message: #LEAP [GAP] XY without previously programming #GAPCTRL ON.

Detection

During block preparation.

Cause

A leap has been programmed using the command #LEAP, which must finish at a certain distance along the plate (GAP parameter). The command #GAPCTRL ON is not programmed. It may be that the GAP parameter is not programmed for the block where the error occurs, but rather a previous #LEAP.

Solution

The possible solutions are:

  • Program #GAPCTRL ON before the #LEAP where error is detected
  • Remove the parameter GAP from the #LEAP commands.

·