Error 2407 · CNC 8058 / 8060 / 8065 · CNC 8070 · CNCelite 8058 / 8060 / 8065 / 8070
Message: #LEAP with #GAPCTRL ON: POSLIMIT less than initial leap coordinate.
Detection
During block preparation.
Cause
There is an axis controlled by the instruction #GAPCTRL ON. In this circumstance, the #LEAP instruction has been programmed with a lower POSLIMIT (maximum leap value) than the start and end leap coordinates.
Solution
The possible solutions are:
- Program POSLIMIT for the #LEAP command with a coordinate greater than the initial leap position.
- Remove the gap control (#GAPCTRL OFF).
