Error 2406 · CNC 8058 / 8060 / 8065 · CNC 8070 · CNCelite 8058 / 8060 / 8065 / 8070
Message: #LEAP with #GAPCTRL ON: The leap must start and end at the same coordinate.
Detection
During block preparation.
Cause
There is an axis controlled by the instruction #GAPCTRL ON. In this circumstance, the #LEAP instruction has been programmed to execute a leap where the start and end coordinates (POS parameter for the #LEAP instruction) do not match.
Solution
The possible solutions are:
- Do not program POS for the #LEAP command
- Remove the gap control (#GAPCTRL OFF).
