Error 2404 · CNC 8058 / 8060 / 8065 · CNC 8070 · CNCelite 8058 / 8060 / 8065 / 8070
Message: #GAPCTRL: The index has been changed for the controlled axis channel.
Detection
During block preparation.
Cause
The possible causes are:
- When the active gap control (#GAPCTRL ON) is on, an instruction is programmed that changes the index for that axis in the channel (#SET AX, #CALL AX, #FREE AX).
- If the machine parameter GAPCTRLCANCEL is set to "NO", the axis remains controlled after the program has finished or following a reset. This error persists if the axis index has been changed under these conditions.
Solution
It is not possible to modify the position of the axes in the channel with the active gap control.
