Error 24023 · CNC 8058 / 8060 / 8065 · CNC 8070 · CNCelite 8058 / 8060 / 8065 / 8070
Message: EtherCAT: Non-Fagor EtherCAT nodes. Software option not allowed.
Detection
During CNC power-up or after a reset.
Cause
The initialisation of EtherCAT has detected some non-Fagor mode and the software option for connecting third-party nodes is not active.
Solution
Remove the non-Fagor modes from the EtherCAT bus or contract the software option for third-party nodes
