Error 4074 · CNC 8055 M · CNC 8055 T
Message: ERROR 301: Ballast circuit of the power supply module heatsink overheated
Detection
During execution.
Effect
It stops the movement of the axes and the spindle, eliminating all the enable signals and canceling all the analog outputs of the CNC. When detected from the position loop, it opens the position loop and sets the LOPEN mark to ·1·.
If it is in execution, it interrupts the execution of the part program of the CNC of all Besides this, it activates the external emergency output.
Cause
An error occurred at the drive.
Solution
Refer to the drive manual.
