Error 2042 · CNC 8055 M · CNC 8055 T
Message: It is recommended to lower the order of the frequency filter.
Detection
On power-up or when pressing RESET after changing the value of the axis parameter or spindle parameter ORDER.
Effect
It stops the movement of the axes and the spindle, eliminating all the enable signals and canceling all the analog outputs of the CNC. When detected from the position loop, it opens the position loop and sets the LOPEN mark to ·1·.
If it is in execution, it interrupts the execution of the part program of the CNC of its channel.
Besides this, it activates the external emergency output.
Cause
The order value of the FAGOR filter can cause overshooting.
Solution
Decrease the value of the order of the filter:
a.m.p ORDER (P70). s.m.p. ORDER (P67).
