Error 1077 · CNC 8055 T
Message: Either the arc radius is too small or a full circle has been programmed
Detection
During execution.
Cause
The possible causes are:
- When programming a full circle using the "G02/G03 X Z R" format.2. When programming using the "G02/G03 X Z R" format, the distance to the arc’s end point is greater than the diameter of the programmed circle.
Solution
The solution for each cause is:
- This format cannot be used to make full circles. Program the coordinates of the end point different from those of the starting point.
- The diameter of the circle must be larger than the distance to the arc’s end point.
