Error 0018 · CNC 8055 M · CNC 8055 T
Message: Program: G22 K(1/2/3/4/5) S(0/1/2).
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
In the function "Enable/Disable work zones (G22)" the type of enable or disable of the work zone has not been defined or it has been assigned the wrong value.
Solution
The parameter for enabling or disabling the work zones "S" must always be programmed and it may take the following values.
S=0: The work zone is disabled. S=1: It is enabled as a no-entry zone. S=2: It is enabled as a no-exit zone.
