Error 0041 · CNC 8055 M
Message: G87: I J K B [C] [D] [H] [L] [V].
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
The parameters have been programmed wrong in the "Rectangular pocket canned cycle (G87)". These may be the probable causes:
- Some mandatory parameter is missing.2. The parameters of the cycle have not been edited in the correct order.
Solution
This type of machining requires the programming of:
The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message. The (X...C) position where the machining takes place can be programmed in this cycle.
I Machining depth.
I Machining depth.
K Dwell at the bottom.
I Machining depth.
J Number of pecks.
I Pocket depth.
J Distance from the center to the edge of the pocket along the abscissa axis.
K Distance from the center to the edge of the pocket along the ordinate axis.
B Defines the cutting depth according to the longitudinal axis.
