Error 0038 · CNC 8055 M
Message: G81-84-85-86-89: I [K].
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
The parameters have been programmed wrong in the following cycles: drilling (G81), tapping (G84), reaming (G85) or boring (G86/G89). This could be because parameter "I : Machining depth" is missing in the canned cycle being edited.
Solution
This type of machining requires the programming of:
The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message. The (X...C) position where the machining takes place can be programmed in this cycle.
