CNC 8058 / 8060 / 8065 CNC 8070 CNCelite 8058 / 8060 / 8065 / 8070

Error 2148 · CNC 8058 / 8060 / 8065 · CNC 8070 · CNCelite 8058 / 8060 / 8065 / 8070

Message: Too many motionless blocks between blocks in spline mode

Detection

During execution.

Cause

While the spline mode is active, there are too many motionless blocks (parameter assignments P, variables, etc.) between two motion blocks.

Solution

Reduce the number of motionless blocks programmed; for example, group several of these blocks into a single block.

·