Error 1041 · CNC 8055 M
Message: Mandatory parameter missing in canned cycle
Detection
During execution.
Cause
The possible causes are:
- In the "Irregular canned cycle with islands" some parameter is missing.
2D POCKETS:
In the roughing operation "G67", either parameter "I" or "R" is missing.
There is no roughing operation and in the finishing operation "G68", either parameter "I" or "R" is missing.
3D POCKETS:
In the roughing operation "G67", either parameter "I" or "R" is missing.
There is no roughing operation and in the semifinishing operation "G67", either parameter "I" or "R" is missing.
There is neither roughing nor semifinishing operation and in the finishing operation "G68", either parameter "I" or "R" is missing.
In the finishing operation "G68", parameter "B" is missing.
- In the "Digitizing canned cycle" some parameter is missing.
Solution
Correct the definition of parameters.
Pocket with islands (finishing operation).
In the irregular pocket canned cycle with islands, parameters "I" and "R" must be programmed in the roughing operation. If there is no roughing operation,they must be defined in the finishing operation (2D) or in the semifinishing operation (3D). If there is no semifinishing operation (3D), they must be defined in the finishing operation. In the 3D pocket, parameter "B" must bedefined in the finishing operation.
Digitizing cycles.
Check the syntax of the block. The programming formats are:
(DIGIT 1,X,Y,Z,I,J,K,B,C,D,F)
(DIGIT 2,X,Y,Z,I,J,K,A,B,C,F)
