Error 0037 · CNC 8055 M
Message: G69: I B [C D H J K L R].
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
The parameters of the "Deep hole drilling cycle with variable peck (G69)". These may be the probable causes:
- Some mandatory parameter is missing.2. The parameters of the cycle have not been edited in the correct order.
Solution
This type of machining requires the programming of:
I Machining depth.
B Drilling peck (step).
The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message. The (X...C) position where the machining takes placecan be programmed in this cycle.
