The parameters for the finishing operation (2D/3D pocket) have been programmed wrong in the "Irregular pocket cycle with islands. These may be the probable causes:

1. A parameter has been programmed which does not match the calling format.2. Some mandatory parameter is missing.3. The parameters of the cycle have not been edited in the correct order.

This machining cycle requires the programming of :

2D pockets 3D pockets The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message. The (X...C) position where the machining takes placecannot be programmed in this cycle.

B Depth of pass.

I Total pocket depth.

R Coordinate of the reference plane.

B Depth of pass.

I Total pocket depth (if no roughing operation has been defined).

R Coordinate of the reference plane (if no roughing operation has been defined).

B Cutting pass (if no roughing operation has been defined).

I Total pocket depth (if no roughing operation has been defined).

R Coordinate of the reference plane (if no roughing operation has been defined).

B Depth of pass.

I Total pocket depth (if no roughing or semi-finishing operation has been defined).

R Coordinate of the reference plane (if no roughing or semi-finishing operation has been defined).