The parameters of the roughing (2D/3D pocket) or semi-finishing (3D pocket)

operation have been programmed wrong in the "Irregular pocket canned cycle with islands". These may be the probable causes:

1. A parameter has been programmed which does not match the calling format.2. Some mandatory parameter is missing.3. The parameters of the cycle have not been edited in the correct order.

This machining cycle requires the programming of :

Roughing operation (2D or 3D pockets)

Semi-finishing operation (3D pockets)

The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message. The (X...C) position where the machining takes placecannot be programmed in this cycle.