Error 0022 · CNC 8055 M
Message: Program: G73 Q (angle) I J (center).
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
The parameters of the "Pattern rotation (G73)" function have been programmed wrong. The causes may be:
- The rotation angle has not been defined.2. Only one of the rotation center coordinates has been defined.3. The rotation center coordinates have been defined in the wrong order.
Solution
The programming format for this function is:
G73 Q (angle) [I J] (center)
The "Q" value must always be programmed.
The "I", "J" values are optional, but if programmed, both must be programmed.
