Error 3003 · CNC 8055 M · CNC 8055 T
Message: Division by zero at the PLC
Detection
Any time.
Effect
It stops the movement of the axes and the spindle, eliminating all the enable signals and canceling all the analog outputs of the CNC. When detected from the position loop, it opens the position loop and sets the LOPEN mark to ·1·.
If it is in execution, it interrupts the execution of the part program of the CNC of all Besides this, it activates the external emergency output.
Cause
In the PLC program, there is a line whose execution implies a division by zero.
Solution
When working with registers, that register may have already acquired a zero value.
Check that the register does not reach the operation with that value.
