Error 1102 · CNC 8055 M · CNC 8055 T
Message: Following error of spindle 1 out of limit
Detection
During execution.
Effect
It stops the movement of the axes and the spindle, eliminating all the enable signals and canceling all the analog outputs of the CNC. When detected from the position loop, it opens the position loop and sets the LOPEN mark to ·1·.
If it is in execution, it interrupts the execution of the part program of the CNC of its channel.
Besides this, it activates the external emergency output.
Cause
When the spindle is working in closed loop (M19), its following error is greater than the values indicated by spindle parameter MAXFLWE1(P21) and MAXFLWE2(P22)
The possible causes for this error are:
Servo drive error Faulty drive.Enable signals missing.
Power supply missing.
Drive adjusted incorrectly.The velocity command signal is not received.
Motor error Faulty motor.Power cables.
Feedback failure Defective feedback.Defective feedback cable.
Mechanical failure Mechanical stiffness.
Spindle mechanically locked.
CNC error Defective CNC.
Parameters adjusted incorrectly.
