Error 0034 · CNC 8055 T
Message: G81-G82: X Z Q R C [D L M F H].
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
The parameters of the canned cycle for "Turning of straight sections (G81)" or for "Facing straight sections (G82)" have been programmed wrong. These may be the probable causes:
- Some mandatory parameter is missing.2. The parameters of the cycle have not been edited in the correct order.
- A parameter has been programmed which does not match the calling format.
Solution
The following parameters must be programmed in this cycle:
The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message.
X-Z Profile starting point I Remaining stock.
C Depth of pass.
S Block where the profile geometry description begins.
E Block where the profile geometry description ends.
X-Z Profile starting point C Depth of pass.S Block where the profile geometry description begins.
E Block where the profile geometry description ends.
X-Z Profile starting point Q-R Profile end point C Depth of pass.
