Error 0030 · CNC 8055 T
Message: G86-87: X Z Q R I B [D L] C [J A].
Detection
While editing at the CNC or while executing a program transmitted via DNC.
Cause
The parameters of the canned cycle for "longitudinal threadcutting (G86)" or for "face threadcutting (G87)" have been programmed wrong. These may be the probable causes:
- Some mandatory parameter is missing.2. The parameters of the cycle have not been edited in the correct order.
- A parameter has been programmed which does not match the calling format.
Solution
The following parameters must be programmed in this cycle:
The rest of the parameters are optional. The parameters must be edited in the order indicated by the error message.
X-Z Profile starting point Q-R Profile end pointC Depth of pass.
I-K Distance from the starting point to the arc center.
X-Z Starting point of the thread.
Q-R End point of the thread.
I Thread depth.B Depth of pass.
C Thread pitch.
